Average Reviews:
(More customer reviews)After being hit in the rear end at a traffic light on my motorcycle, I decided I must do SOMETHING to attract attention of drivers behind me.The solution?The Back Off device is a safety MUST.It is simple to install.On my M109R I simply took off the seat, found the brake wire, cut it, and hooked up the Back Off box inline with two wire crimps and some black electrical tape.Now, when I engage my brakes the tail lights give four short flashes, one long flash, then repeats until the brake is released.After installing, I even had a lady at a traffic light pull up beside me and complain that my flashing brake lights was "disturbing" to her!My answer?"GOOD!"
This is a cheap safety tool that no motorcycle on the road should be without.
Click Here to see more reviews about: SIGNAL DYNAMICS BRAKE LIGHT SIGNAL MODUEL 1001
Product Description:
This compact solid-state electronic module converts your ordinary brake light into an attention-getting- visual-alerting device Module causes three short flashes- stays on for 3.5 seconds- then repeats the cycle for as long as the brake is on Specifications: 12V DC- max capacity 10 amps- 2 1/4`` L x 1 5/8`` W x 5/8`` H Features sealed- weather-resistant heat sink case Made in the U.S.A.Photo`s are for reference only. Please read item title carefully.
Get 16% OFF
Want to buy SIGNAL DYNAMICS BRAKE LIGHT SIGNAL MODUEL 1001 at other amazon sites? Click the corresponding icon below:
0 comments:
Post a Comment